Setting Pico Log up

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
Author Message
Fiona
Guest
PostPosted: Tue Nov 05, 2002 1:09 pm    Post subject: Setting Pico Log up Reply with quote
I spend a lot of my time calculating results from raw collected values, but don't need them afterwards. It takes a long time to set up picolog and I still have all of the raw data fields cluttering the screen. Is there any way I can make Picolog start up as I left it and remove the raw values from the display.
Back to top
James
Guest
PostPosted: Wed Nov 06, 2002 3:33 pm    Post subject: Pico Log settings Reply with quote
To remove unwanted measurements from PicoLog's main screen use the Settings Monitor dialogue box to highlight and select those which you wish to keep.

To make Picolog start as it was left you can save your settings as a .pls file which can be reloaded. To save this file, set up Picolog as you would like it and then go to File / Save as , changing the file type to .pls.

You can also make Picolog open with this settings file already open by right clicking on the icon, selecting properties and changing the target to

[Path]\plw32.exe [path]\MySettings.pls where [path] is usually c:\PICO

To make PicoLog start taking results when the logger is opened use:
[Path]\plw32.exe -r [path]\MySettings.pls.
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group