ADC=100 Hardware not working

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Getting Started
Author Message
BrianDSmith
Guest
PostPosted: Fri Nov 29, 2002 8:11 pm    Post subject: ADC=100 Hardware not working Reply with quote
Software installs ok. Help->About shows 60k samples/sec maximum.

Meter will not display 1.5 volt battery connected to Input A. Scope display clips inputs, sine, square and triange show up as square wave. Deflection shows only 1/2 division deflection.

Frequency of display is ok, but all inputs are clipped to a square.

Is there a self-diagnostic proceedure?

Brian
Back to top
mark
Guest
PostPosted: Mon Dec 02, 2002 9:20 am    Post subject: Reply with quote
Brian

Unfortunatley, there are no self diagnostic functions within the ADC100. However, your problem does sound like the ADC100 needs an adapter.

For more information, check out

http://www.picotech.com/support/viewtopic.php?t=63
Back to top
BrianDSmith
Guest
PostPosted: Mon Dec 02, 2002 4:22 pm    Post subject: ADC-100 problem Reply with quote
Mark

The adapter fixes the problem. Thanks.

I still cannot get the voltmeter to diplay any DC volts. The scope display shows a proper DC voltage is present. The AC voltmeter has the same problem. The scope display shows an AC voltage but the voltmeter display show zero volts.

Any help is appreciated.

Brian
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Getting Started
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group