|
|
| Author |
Message |
tehpeh
Newbie
Joined: 24 Jun 2008
Posts: 1
|
 Posted: Tue Jun 24, 2008 12:46 pm Post subject: Unable to use triggers in v6.0.15 |
 |
|
Hi
I have recently upgraded from SW version 6.0.13 to 6.0.15 and since then I can't make the trigger work. I use single trigger with Repeat mode, but I can get only a "free running" graph. In the previous version it was all fine.
Furthermore, when I move the trigger point (yellow rhombus) on the screen, the trace on the screen moves as well. if I place the trigger one division from the the left side of the screen, the signal runs from left up to one position from the right.
When I move the trigger towards the centre, the trace seems to be shifted right.
I have tried to reset the User Preferences, but it did no change.
What am I doing wrong to make the trigger work?
Cheers |
|
| Back to top |
|
 |
Guest
|
| Posted: Tue Jun 24, 2008 11:00 pm Post subject: |
|
|
| trigger doesn't work in R6.0.15. see R6 forum it's already been answered by picotech. |
|
| Back to top |
|
|
ziko
Site Admin
Joined: 01 Dec 2006
Posts: 706
Location: St Neots
|
| Posted: Wed Jun 25, 2008 11:15 am Post subject: |
|
|
Hi this is true the next release has this fixed, in the mean time could you un-install the current version and install 6.0.14 which can be found on
http://www.picotech.com/software-archive.html
Apologies for any inconvenience.
Kind regards |
|
| Back to top |
|
|
|
Cart
Email