Running ADC20 and TC08-USB simultaneously

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
Author Message
Guest
PostPosted: Tue Jun 03, 2008 6:46 am    Post subject: Running ADC20 and TC08-USB simultaneously Reply with quote
Hello all together,

I would like to run 2 interfaces e.g. ADC 20 and TC08-USB on my laptop. When installing the driver SW Pico Full V 5.20.1 I am asked the question for the typ of interface I would like to run. Depending on which I select the corresponding *.dll will be selected. That means I have to reinstall the application when changing of the interface. Otherwise the error message "usbtc08T.dll" or "PicoHRDL.dll" will be posted. That means in addition, I could never run both interfaces simultaneously. Or is there a way nevertheless to install the driver SW in a specific way to be able to do this?
Very best regards // Siggischatzi
Back to top
picojohn
Site Admin
Site Admin


Joined: 11 Jun 2007
Posts: 391

PostPosted: Tue Jun 03, 2008 10:08 am    Post subject: Reply with quote
Hello Siggischatzi,

Please refer to section 3.12 of PicoLog user guide (http://www.picotech.com/document/pdf/plw044.pdf) for information on running multiple instances of PicoLog, which is what will be required for your chosen combination of products.

You may also need to remove and reinstall PicoLog, but make certain that you tick the box at device selection to support other devices.

Regards
John
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group