Multiple TC-08

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
Author Message
Guest
PostPosted: Fri May 09, 2008 6:45 pm    Post subject: Multiple TC-08 Reply with quote
I have an application to monitor more than 8 points, so multiple units would be needed.

How do you use more than 1 serial unit? Is there a way to daisy chain them?

If I use the USB model, I imagine that I would need a USB hub. Is that correct?

Thanks...

Dave in the USA
Back to top
picojohn
Site Admin
Site Admin


Joined: 11 Jun 2007
Posts: 391

PostPosted: Mon May 12, 2008 2:52 pm    Post subject: Reply with quote
Hello Dave,

Please view the following:

http://www.picotech.com/support/kb/DataLoggers-kb215

http://www.picotech.com/support/kb/DataLoggers-kb157

If you wish to use the serial TC-08, then you shall require one serial port per TC-08 on your computer.

If your computer provides sufficient USB ports, then you would not require a hub for the USB TC-08 devices. If not, then you are correct.

reghards
John
Back to top
Guest
PostPosted: Mon May 12, 2008 4:48 pm    Post subject: Thanks Reply with quote
Thanks. Do you have any distributors in the USA?
Back to top
picojohn
Site Admin
Site Admin


Joined: 11 Jun 2007
Posts: 391

PostPosted: Wed May 14, 2008 9:26 am    Post subject: Reply with quote
Hello Dave,

You will find the USA distributors at: http://www.picotech.com/distribl/usa.html

Regards
John
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group