Connecting different converter types

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Enviromon System
Author Message
Guest
PostPosted: Thu Feb 07, 2008 3:38 pm    Post subject: Connecting different converter types Reply with quote
Hi,

We have EL040 and EL001 converters, which we have been using separately for some time now. However, now we're looking to monitor the current draw of an electric water heating system and would like to operate both onverters at the same time.

We can't seem to manage this unfortunately. With both converters connected to the logger (EL005) we get the error message "converter fail". However, when we unplug one of the converts the other works as normal.

Is it possible to use these two converter types at the same time?

Thanks
Back to top
picojohn
Site Admin
Site Admin


Joined: 11 Jun 2007
Posts: 371

PostPosted: Mon Feb 11, 2008 10:03 am    Post subject: Reply with quote
Hello Guest,

Please refer to section 4 of the user manual (http://www.picotech.com/document/pdf/emw044.pdf) for instructions on configuring the system, paying particular attention to paragraph 4.2.4, 'Setting converter addresses'.

If you are still experiencing difficulty after consulting the user manual, please send us an email to support@picotech.com, for a detailed response.

Regards
John
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Enviromon System
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group