Pico Technical Support and Discussion Forum

eric76 · User Joined: 11 May 2007 Posts: 3

Hello from FRANCE,

I've just installed the last software and I have a problem with channel A, B works fine.

There is a little red icon on channel A but I don't find anything about it:

ziko · Posted: Fri May 11, 2007 4:22 pm Post subject:

Hi and thank you for your post.

What product are you using? I also noticed that you have the voltage range at 500mV if your voltage range goes above this then the red icon will appear to warn you that you have exceeded the voltage in that range.

Let me know how you get on.

eric76 · User Joined: 11 May 2007 Posts: 3

It is a Picoscope3204
Whatever I m doing Channel is at the top of the screen and after an autoset the voltage range goes to 20V but the red icon is always there.

ziko · Posted: Mon May 14, 2007 8:20 am Post subject:

Hi, could you tell me and try the following:

1) What are your input voltages?
2) Have you tried changing your input channels and seeing if you have the same problem?
3) What version of the software are you using? (Help->about)
4) Have you tried removing the software and reinstalling it in English?

Kind regards

eric76 · User Joined: 11 May 2007 Posts: 3

Whatever the input voltage is the Channel A is at the top , even with no input or the same input as B.

Last sofware 5.16.2.

Same problem in english

ziko · Posted: Mon May 14, 2007 9:05 am Post subject:

Hi,

This seems to be a problem with channel A, please email us at support@picotech.com and put FAO of Ziko on the subject heading. The product may need to be repaired.

Kind regards

Pico Technology

Pico Technical Support and Discussion Forum