problem in PicoLog with ADC200

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
Author Message
Guest
PostPosted: Mon Nov 19, 2007 8:49 am    Post subject: problem in PicoLog with ADC200 Reply with quote
Hello,

I am using ADC 200 along with Wincapp and PicoLog softwere. I am using this system to monitor the current and voltage flowing through the electrochemical cell. I have attached a duel cathode reverse pulse rectifier to this system.

I found that the current noted by Picolog softwere is not same as that of shown by rectifier. I checked the system and think that current shown on the panel of rectifier might be the correct one. So something is worng on the PicoLog. Can any body please help me to get accurate current voltage graph.
Thank you
Back to top
picojohn
Site Admin
Site Admin


Joined: 11 Jun 2007
Posts: 391

PostPosted: Wed Nov 21, 2007 4:49 pm    Post subject: Reply with quote
Hello Guest,

Could you explain what Wincapp is, and also, how you are connecting the ADC-200 to monitor current and how PicoLog has been setup.

If you could send a copy of the .plw file from your recording session to support@picotech.com for my attention, that may also be useful.

Regards
John
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group