EnviroMon

Changing converter address

In the EnviroMon System all units are issued with an address, which is written on the converter at time of purchase.

At times you may find multiple converters with the same address. The addresses have to be unique thus the configuration will not be successfully completed if units are trying to share a common address.

To change a converter address the application called 'change converter address' is used. This should be installed during the installation of EnviroMon software.

  1. Start Change converter address application.
  2. Connect the logger to the PC, only one converter should be connected at a time.
  3. Select the new address number and select the port that the logger is connected to.
  4. Program the logger and then use read back to check the address has been changed correctly. Change the number on the converter as a reminder of the converters address.
  5. Repeat 2 - 4 for other converters

Article: KB-145
12 Jul 2007

< EnviroMon knowledge base