Data Loggers

Trigger in PicoLog (fast block only)

Triggering in Picolog is available, but only in fast block mode.
To use this:

  1. Open the Recording window File | New Settings
  2. In the ‘Recording Method’ dropdown box select the option ‘Fast Block’. (When using this mode you will only be able to use one convertor at a time.)
  3. Click OK.
  4. Select the Unit that you want (Not all units are available, only units that can be used with Picoscope.)
  5. Click OK.
  6. Add the channel and select ‘trigger’.
  7. Click the ‘Trigger enable’ check box.
  8. Choose the direction that you want the trigger to action on.
    eg rising the voltage is increasing. Falling the voltage is decreasing.
  9. In the Threshold box enter the voltage level that you want the trigger to action.

Article: KB-154
15 Jun 2007

< Data Loggers knowledge base