Drdaq not in lpt0 error

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Getting Started
Author Message
BEHIRI KHALED
Guest
PostPosted: Sat Feb 21, 2004 10:44 am    Post subject: Drdaq not in lpt0 error Reply with quote
In my laptop (HP XE3 omnibook, windows 2000), the ADC-200 is working ok in LPT1 witch is the unic parralele port in this laptop. when conecting DrDAQ to this port and changing the setup in Picoscope menu for selecting Drdaq as the actual convertor, and reseting after the cpu to active this selection. I receive message error " Drdaq not in LPT0" when Im traying to run it with picoscope software, same with picolog. I tray to install again the original software (R5-08.4), the same problem persist for DrDAQ, please not that the red led in DrDAQ card is ok: flasching during windows startup (there is communication) and give fix light after that. please help me to enjoy with my new product DrDAQ.

regards,


khaled behiri
behiri_kha1968@yahoo.com
Back to top
markspencer
Site Admin
Site Admin


Joined: 07 May 2003
Posts: 610

PostPosted: Mon Feb 23, 2004 9:19 am    Post subject: Reply with quote
Hi,

Have a look at your parallel port settings.

The mode should be on of the following:
SPP, Unidirectional, Normal or Output only.

It should not be set to, Bidirectional, ECP, EPP. Although these will work on occations it can be tempermental.

If you are still unable to get the DRDAQ to work as expected try it on a different PC, preferably with Win98. If it still will not work the unit may need to be returned to us for investigation.

Best regards,
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Getting Started
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group