Pico Technical Support and Discussion Forum

glennsklar · Guest

Please suggest the product needed to record the following data:

: DC current vs time (sec), and voltage vs. time (sec), simultaneously.

: Pulsed DC current vs time (millisecond), and pulsed voltage vs time (millisecond), simultaneously.

: Verification of rectifier pulsed output in the millisecond range by oscilliscope.

Thank You.

markspencer · Site Admin Joined: 07 May 2003 Posts: 607

Hi,

Thank you for your enquiry.

Unfortunately, I cannot recommend or units for this, as the samples for different channels cannot be guaranteed to be taken at the same time.

Best regards,
Mark S.

Guest · Posted: Fri Mar 26, 2004 2:57 pm Post subject:

I have a similar application but with larger timescales, to what extent are samples of different channels likely to be "out of sync" ? Can your devices be configured to act as a virtual chart recorder ?

Ian Meredith

markspencer · Site Admin Joined: 07 May 2003 Posts: 607

Hi,

Thank you for your question.

Unfortunately, I am unable to state an exact time that the channels are our of sync. It could be milliseconds, it is dependent on own the software collects the data.

Picolog can be used in place of a chart recorder. A graph of each channel can be produced from the data and the readings viewed in a spreadsheet.

I would advise downloading the demo software, just follow the download link.

Best regards,

Pico Technology

Pico Technical Support and Discussion Forum