Multiple pico scopes working together

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoScope
Author Message
Guest
PostPosted: Sat Mar 22, 2008 11:18 am    Post subject: Multiple pico scopes working together Reply with quote
I investigationg the pico scopes.

1. Is it possible to use two or more pico-scopes together; maybe triggering on one channel?

2.Does the software allow for this?

Thanks!
Back to top
picojohn
Site Admin
Site Admin


Joined: 11 Jun 2007
Posts: 333

PostPosted: Tue Mar 25, 2008 10:46 am    Post subject: Reply with quote
Hello Guest,

It is possible to run more than one USB oscilloscope using multiple instances of PicoScope 6, but each unit is independent.

Regards
John
Back to top
Guest
PostPosted: Thu Apr 03, 2008 7:39 pm    Post subject: Multiple scopes Reply with quote
Thanks John.

I find this quite odd. Technically it is quite simple to implement.

I would have designed the scopes to have trigger in and trigger out bnc connectors. Multiple units could be connected in a circular fasion. The software could then set up any channel as the trigger start, force a trigger in the associated unit and measure the delay through the triggers. The software could then re-construct all the channel's data, sequence allowing for delays and display it on screen.

Maybe something to think about at pico?

Thanks
Willem
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoScope
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group