|
|
| Author |
Message |
Guest
|
 Posted: Sun Mar 16, 2008 7:44 pm Post subject: phase mesurements and frequency response |
 |
|
Hi,
I have an ADc212-50 parallel .
Is it possible to mesaure the phase, in degrees, between two signals?
In addition, I try to have a frequency response beteen 10hz to 200KHz; on high frequency I have n problem, at low freq. is not possible to have a good resolution, can ypu help me?
Bye
Walter |
|
| Back to top |
|
 |
ziko
Site Admin
Joined: 01 Dec 2006
Posts: 586
Location: St Neots
|
| Posted: Tue Mar 18, 2008 11:34 am Post subject: |
|
|
Hi and thank you for your post.
There are no phase calculation in our software, however you can do an XY graph on PicoScope 5.
In terms of your frequency response, in the spectrum view you can choose the appropriate number of bins then choose peak hold. Now if you can sweep up with a a seperate sig gen and do that many times you can build up your frequency response.
Hope this helps |
|
| Back to top |
|
|
Guest
|
| Posted: Sun Apr 06, 2008 9:37 am Post subject: |
|
|
Hi thanks for answer.
In wich way I can save as .jpg a page with x and o details.
I tried without succes, I found only the wave or spectrum without details.
Bye
Walter |
|
| Back to top |
|
|
ziko
Site Admin
Joined: 01 Dec 2006
Posts: 586
Location: St Neots
|
| Posted: Mon Apr 14, 2008 10:42 am Post subject: |
|
|
Hi Walter,
Currenlty you cannot save the measurements when saving an image file, I have put it as a suggestion to the relevant people.
Kind regards |
|
| Back to top |
|
|
|
Cart
Email