|
|
| Author |
Message |
Anders Westergaard
Active User
Joined: 04 Sep 2006
Posts: 8
|
 Posted: Tue Apr 10, 2007 8:05 am Post subject: Save as txt problem |
 |
|
In PicoScope R5.x "Save as" offered the possibillity to save a scope trace as txt and "Édit->Copy as text" would save the current screen depending of zoom factor and probe scaling to the clipboard.
In R6 it seems that it is always the current trace that are either saved or copied to clipboard and the probe scaling and zoom factor are NOT taken into consideration.
I would very much like to be able to save all traces as txt, save the current trace as txt and copy the current view to the clipboard. It would be preferable if this could be done using the same scaling (voltage and time) as in R5 and that zoom and probe information ard actually used when copying to clipboard.
Br Anders Westergaard |
|
| Back to top |
|
 |
ziko
Site Admin
Joined: 01 Dec 2006
Posts: 586
Location: St Neots
|
| Posted: Wed Apr 11, 2007 1:02 pm Post subject: |
|
|
Hi and thank you for your post.
Unfortunately, since the software is still in an early stage of development, only very simple data export features exist, and they will not always allow post-processing of the entire data-set or scaling in the method that you might prefer. This will all be possible in future (we have plans for a very flexible data export system), but we can't give timescales at this stage. PicoScope 5.x can still be used for this purpose until PicoScope 6 implements these features.
Kind regards |
|
| Back to top |
|
|
ServoTech
Active User
Joined: 24 Mar 2008
Posts: 7
Location: Radford, Virginia, USA
|
| Posted: Mon Mar 24, 2008 4:05 pm Post subject: Saving Data as Text File |
|
|
Hi Forum,
Is there any update to this? I am unable to save using V6 also. It is now nearly a year later, however.
Best regards,
Mike
 |
|
| Back to top |
|
|
ziko
Site Admin
Joined: 01 Dec 2006
Posts: 586
Location: St Neots
|
| Posted: Thu Mar 27, 2008 1:22 pm Post subject: |
|
|
Hi ServoTech,
Yes you now can save the current waveform as .txt, .csv and .mat file, also the limit has been extended to 1Million points.
Hope this helps. |
|
| Back to top |
|
|
ServoTech
Active User
Joined: 24 Mar 2008
Posts: 7
Location: Radford, Virginia, USA
|
| Posted: Thu Mar 27, 2008 2:14 pm Post subject: Saving as .csv and .txt |
|
|
Hi Ziko,
Is there a new software release for this function? What is rev. number?
Thank you!
Mike
 |
|
| Back to top |
|
|
ziko
Site Admin
Joined: 01 Dec 2006
Posts: 586
Location: St Neots
|
| Posted: Fri Mar 28, 2008 9:42 am Post subject: |
|
|
Hi it has was done a few releases ago. Try the latest software 6.0.13.
Kind regards |
|
| Back to top |
|
|
|
Cart
Email