Pico Technical Support and Discussion Forum

KajV · Guest

How to set Do1 and DO2 in picolog on ADC-11-USB?

ziko · Posted: Wed Feb 07, 2007 1:54 pm Post subject:

Hi and thank you for your post.

You are lucky I recently added this in our example file. Please find attached the excel file. If you have any further questions please do not hesitate to contact me.

Kind regards

Kajv · Guest

That's true, but when i start Picolog, the signal is switched off.
I would like to use Picolog.
Best regards.

ziko · Posted: Wed Feb 07, 2007 3:48 pm Post subject:

Hi you cannot set the DOs in PicoLog and hence you have to write your own software to do so.

Kind regards

KajV · Guest

Thank you.
That's too bad. Sad

By the way Picolog service is using 99%CPU-power. That sould not be nessecary. Question

Best Regards.

ziko · Posted: Fri Mar 16, 2007 5:39 pm Post subject:

Hi and thank you for your post.

It does use a lot of CPU time when it recording the data, this is normal.

Kind regards

Guest · Posted: Mon Jul 21, 2008 2:41 pm Post subject:

Why was it possible earlier to do this with parallel port ADC11? Is it possible to turn on digital output permanently on USB devices with out soldering?

ziko · Posted: Wed Jul 30, 2008 3:40 pm Post subject:

Hi I do not recall that you permanently set the DO to high on the parallel ADC11, both units share the same terminal board though.

Kind regards

Guest · Posted: Thu Sep 18, 2008 12:25 pm Post subject: CPU Time

Pico Technology

Pico Technical Support and Discussion Forum