Resistance for the terminal block

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
Author Message
J Minns
Guest
PostPosted: Mon Aug 21, 2006 10:29 pm    Post subject: Resistance for the terminal block Reply with quote
I have an amplifier from a strain guage amplifier which gives a 10V output to the terminal block. How do I calculate the reistance needed in a Potential divider situation ao that the max Vin is 2.5V. I am referring to an ADC 11/12 USB device and associated terminal block.

I have DasyLab software, how can I input the ADC 11/12 into their software?

Thanks for any help
Back to top
Michael
Guru
Guru


Joined: 07 Jul 2005
Posts: 93
Location: St Neots, Cambridgeshire
PostPosted: Wed Aug 23, 2006 8:03 am    Post subject: Reply with quote
Hello,

I have attached the terminal board document used for calculating resistor values for potential dividers.

I believe that DasyLAB software will be able to access our devices directly from the dll files. You will need to consult the DasyLAB manual for confirmation.

Best regards,
Michael

Terminal Boards General.pdf
 Description:

Download
 Filename:  Terminal Boards General.pdf
 Filesize:  1.02 MB
 Downloaded:  159 Time(s)
ADC11_TerminalBoard_Instructions.pdf
 Description:

Download
 Filename:  ADC11_TerminalBoard_Instructions.pdf
 Filesize:  68.26 KB
 Downloaded:  168 Time(s)
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group