Pt104 no temp reading

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Serial Port Products
Author Message
joe
Guest
PostPosted: Fri Aug 26, 2005 4:50 am    Post subject: Pt104 no temp reading Reply with quote
Hi, using the pt104 with seven channels (2 units).
The pico recorder software "sees" the pico units as it gives a calibration date and some number after it when I hit "status".
I can not get temp readings after renaming the channels: "******* deg C"
Using the 4 wire option, I buzzed out the wires and the resistor. I simplified it down to one temp unit. Can't get it to read. Any help?
Oh, I've tried two versions of the SW.
Is there a "go" button I'm an missing or something? Confused
Back to top
Guest
PostPosted: Fri Aug 26, 2005 4:52 am    Post subject: Re: Pt104 no temp reading Reply with quote
To elaborate further: If I disconnect the units or the cables it give the error: can't open com port. That coupled with the status functionality makes me think I am actually seeing the pt104s.
Back to top
Guest
PostPosted: Sun Aug 28, 2005 1:25 am    Post subject: Re: Pt104 no temp reading Reply with quote
Anonymous wrote:
To elaborate further: If I disconnect the units or the cables it give the error: can't open com port. That coupled with the status functionality makes me think I am actually seeing the pt104s.

I used an old driver to fix it. Uninstall did not actually uninstall the software, so I had to manually erase, then reinstall. THANKS PICO
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Serial Port Products
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group