Wrong Voltage dispaly with PicoLog and ADC101

 
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
Author Message
Viktor Andor
Guest
PostPosted: Mon Feb 21, 2005 6:48 pm    Post subject: Wrong Voltage dispaly with PicoLog and ADC101 Reply with quote
Hello,

I downloded today the latest release R5.12.0 and after instalation I get the same problem as with the previously instaled version R5.10.07, namely the voltage display swings between 0 and approx. 1.2 V independent from the actual voltage. This problem accurs after updating my laptop operating system from Win 98 to Win 2000. I use the parellel port conection together with ADC 101 The Voltage range for the measurements I selected was +/- 10 V. The actual volage range of the measured data is DC from 0 to 10V. The parallel port setting in BIOS is bidirectional enabled.

I thank you anticipated
Viktor
Back to top
Sarah
Guest
PostPosted: Tue Feb 22, 2005 10:04 am    Post subject: Reply with quote
Hi

Thank you for your post.

Possibly the reason you are seeing problems is that the mode of the parallel port in the BIOS should be set to one of the following:

Standard, Normal, SPP, Output, Only, Unidirectional

It shouldn't be set to bidirectional, ECP or EPP as these are not optimal for the function of our units.

Thus, I would recommend changing your parallel port settings and seeing if this helps.

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> PicoLog
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group