ADC 100 - Problems

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Getting Started
Author Message
picofan
Guest
PostPosted: Mon Feb 14, 2005 10:39 am    Post subject: ADC 100 - Problems Reply with quote
Confused
I have problems with my ADC100, it runs but doesn't display the voltage correctly.

My setup:

Win2000Pro.
I downloaded V5.12.0 as suggested and installed
I removed the F0:2 patch from win.ini
I left UseAdapter in win.ini and still have the adapter connected

The Driver files are V3.00
Pico.sys is V2.0
When I go to help>about it says i have no adapter

My Problem:

If I load Pico Scope and run with auto scale and no signal, the scope displays a trace at -20V with about 2v of noise spikes.
If the i/p is shorted the same happens
With 0V i/p, displays -20V flat line
If I adjust the voltage with a variable PSU, the trace moves between -16V and -20V randomly.

If I load Pico Recorder V5.12.0 with a +/- 5 V range
i/p 0v it displays -4.9V
i/p 5v displays -4.4V
i/p 10v displays -4.4V

How can I solve this problem please??

Many Thanks

James
Back to top
Sarah
Guest
PostPosted: Tue Feb 15, 2005 10:33 am    Post subject: Reply with quote
Hi James

Thank you for your post, I am sorry to hear that you have been experiencing problems.

How have you entered the UseAdapter patch into the win.ini file?

You need to enter the following, on a new line of it's own:

[ADC100]
UseAdapter=Yes

Make sure you have entered it like this, then save the file and restart Picoscope. It should now report that it is using the adaptor. You may need to restart windows for the changes to take effect.

Hope this helps

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Getting Started
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group