collecting data from 212/100

 
Post new topic   Reply to topic    Pico Technology Forum Index -> General Software Discussions
Author Message
Lucio
Newbie


Joined: 19 Jan 2005
Posts: 1

PostPosted: Wed Jan 19, 2005 5:13 pm    Post subject: collecting data from 212/100 Reply with quote
Hi there,

i'm using the 212/100 to read a voltage signal froma pressure gauge.
I must confess that practically I don't konw anything about programming...

...so please can you tell me how I can store in a file the data that the oscilloscope prgressively collects?

i've installed the r5_11_08 version and the drivers weba200_r4_00.

i've tried with DDE, but the data are overwritten everytime.
I've also tried to launch the execl macro and see if I could put my hands in and change some setting but it tells me:

Unable to open ADC-200
ADC200 Driver V4.01
Error 13 (H0 S0)


and before that when it says:

Select Tools/Macro
Select GetData
Press Edit
Set the following variables:


there are no specifications on which variables to set!!!

please let me know asap because i'm stuck with my work!!!
Thanks,

Lucio
Back to top
Sarah
Guest
PostPosted: Thu Jan 20, 2005 9:42 am    Post subject: Reply with quote
Hi

Thank you for your post.

Would using our Picolog software help? This enables you to record the data that is coming in and you can then export it to Excel after it has been collected. This would be easier than writing your own software.

Hope this helps

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> General Software Discussions
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group