Running multiple 3200- or ADC-200 Series Scopes in PARALLEL

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
Author Message
alehander
User
User


Joined: 18 Jan 2005
Posts: 2
Location: San Luis Obispo, CA
PostPosted: Tue Jan 18, 2005 6:35 pm    Post subject: Running multiple 3200- or ADC-200 Series Scopes in PARALLEL Reply with quote
Hello, all. I need to track, trigger on and log complex analog waveforms at 25MHz+ for long time spans (hours). Looks like the 3200- or ADC-200 series scopes will do the trick, aside from the 2-channel limitation. I need 4 channels minimum. Is there a possibility of running multiple 3200- or ADC-200 series scopes in parallel? If so, what sorts of limitations should I expect (reduced sampling/logging bandwidth?). Thanks for the help,

Alex Bugrov
Back to top
Sarah
Guest
PostPosted: Wed Jan 19, 2005 10:28 am    Post subject: Reply with quote
Hi

Thank you for your post.

Generally it is not recommended to use multiple oscilloscopes at a time. The Picoscope software will not support the use of more than one unit.

If you wish to use multiple units with Picolog then you will be limited to Real Time Continuous mode which has a maximum sampling rate of one per ms. There would be no limitations to bandwidth.

Hope this helps

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group