TC-08 Temp and resistance

 
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
Author Message
St3ve
Guest
PostPosted: Thu Jan 06, 2005 4:23 pm    Post subject: TC-08 Temp and resistance Reply with quote
Hello,

I have a requirement for temperature measurement as well as resistance measurement. The TC-08 looks ok for the temp measurement, but is there a way to do resistance measurement also with this unit? I have seen that the PT-104 could do both but it only has 4 channels.

Many thanks
Back to top
Sarah
Guest
PostPosted: Fri Jan 07, 2005 11:06 am    Post subject: Reply with quote
Hi

Thank you for your post.

The TC-08 will accept voltages of ±70mV, therefore if you can create some small circuit to utilise this voltage input in order to measure resistance, then you could potentially use the TC-08. It is very important however that you do not exceed the ±70mV limit as this could damage the unit.

Hope this helps

Best Regards
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Pico Technology Forum Index -> Pre-Sales Advice
All times are GMT
Page 1 of 1

 


Pico Technology topic RSS feed 
Powered by phpBB © 2001, 2005 phpBB Group